pcb-tips

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revisionPrevious revision
Next revisionBoth sides next revision
pcb-tips [2021/01/17 16:23] – benhpcb-tips [2021/01/19 13:02] – benh
Line 5: Line 5:
   * Higher polygon isolation will reduce the chance of bridging to a plane during assembly (since we don’t really offer soldermask). However, it will also increase etch time because more of the substrate will be etched. "Isolataion" is usually a setting that you can edit per specific polygon; 10 mil is the default often, but 24 or 32 mil (or more, though the benefits decrease) will reduce the risks further.    * Higher polygon isolation will reduce the chance of bridging to a plane during assembly (since we don’t really offer soldermask). However, it will also increase etch time because more of the substrate will be etched. "Isolataion" is usually a setting that you can edit per specific polygon; 10 mil is the default often, but 24 or 32 mil (or more, though the benefits decrease) will reduce the risks further. 
   * We haven't done a lot of slots, so YMMV. If you figure out a good method, let us know.    * We haven't done a lot of slots, so YMMV. If you figure out a good method, let us know. 
-  * If you're interested in optimizing your ProtoLaser experience, see the [[https://drive.google.com/file/d/1rF-XXszzSLil9l0rhl82kTUsCyUagpYU/view?usp=sharing|LPKF ProtoLaser Optimization]] document for more information.+  * If you're interested in optimizing your ProtoLaser experience, see the [[https://gtvault.sharepoint.com/:b:/s/HiveMakerspace/EZGQyfhrC0BItpbSxd_rjRQBzDyNWUubu-RCuJr6a3OI9A?e=8kXjaA|LPKF ProtoLaser Optimization]] document for more information.
  
 [[pcb-book-of-kane|The Book of Kane]] [[pcb-book-of-kane|The Book of Kane]]
  • pcb-tips.txt
  • Last modified: 2023/09/05 13:37
  • by benh