pcb-tips

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revisionPrevious revision
Next revision		Previous revision
Next revisionBoth sides next revision
pcb-tips [2021/01/14 22:56] – benhpcb-tips [2021/01/19 13:02] – benh
Line 5: Line 5:
   * Higher polygon isolation will reduce the chance of bridging to a plane during assembly (since we don’t really offer soldermask). However, it will also increase etch time because more of the substrate will be etched. "Isolataion" is usually a setting that you can edit per specific polygon; 10 mil is the default often, but 24 or 32 mil (or more, though the benefits decrease) will reduce the risks further.    * Higher polygon isolation will reduce the chance of bridging to a plane during assembly (since we don’t really offer soldermask). However, it will also increase etch time because more of the substrate will be etched. "Isolataion" is usually a setting that you can edit per specific polygon; 10 mil is the default often, but 24 or 32 mil (or more, though the benefits decrease) will reduce the risks further. 
   * We haven't done a lot of slots, so YMMV. If you figure out a good method, let us know.    * We haven't done a lot of slots, so YMMV. If you figure out a good method, let us know. 
 +  * If you're interested in optimizing your ProtoLaser experience, see the [[https://gtvault.sharepoint.com/:b:/s/HiveMakerspace/EZGQyfhrC0BItpbSxd_rjRQBzDyNWUubu-RCuJr6a3OI9A?e=8kXjaA|LPKF ProtoLaser Optimization]] document for more information.
  
 [[pcb-book-of-kane|The Book of Kane]] [[pcb-book-of-kane|The Book of Kane]]
  • pcb-tips.txt
  • Last modified: 2023/09/05 13:37
  • by benh