Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revision | Next revisionBoth sides next revision | ||
process_stencils [2022/05/23 11:55] – benh | process_stencils [2022/05/23 12:21] – benh | ||
---|---|---|---|
Line 41: | Line 41: | ||
- Move the pilot laser (double-click) to the corners of your design to confirm that the >= 1" boarder exists for all four edges. If not, you will have to either move the design again (with the " | - Move the pilot laser (double-click) to the corners of your design to confirm that the >= 1" boarder exists for all four edges. If not, you will have to either move the design again (with the " | ||
- Once the design is properly placed within the polyimide, press the green play button in the toolbar (or " | - Once the design is properly placed within the polyimide, press the green play button in the toolbar (or " | ||
+ | - After processing, you may need to bend the stencil a bit to make sure all the little bits are out. Check with the jeweler' | ||
---- | ---- |