Before starting, make sure:

• you're logged into SUMS;
• the ProtoMat and software are running; and
• the ProtoLaser are software are on and warming up.

Step 1: Process setup and first drilling on the ProtoMat

• The ProtoMat will pause at a step called “Dismount Material”.
• Once it reaches that point, remove the substrate from the ProtoMat and click “Abort” in the Wizard.
• Continue with Step 2.

Step 2: Electroplating with the Contac S4

Step 3: Etching with the ProtoLaser

Step 4: Routing with the ProtoMat

• Some issue