This is an old revision of the document!

Before starting, make sure:

Step 1: Process setup and first drilling on the ProtoMat

  • After completion of Step 1, the ProtoMat will pause at a step called “Flip Material”.
    • If it pauses at a step called “Dismount material” instead, DO NOT PANIC! You selected something during the Process Planning Wizard for through-hole plating equipment, when you should've left it blank. But no worries - simply leave the software and continue with these steps as though everything is hunky-dory.
  • Once the software has paused, lift the ProtoMat's lid. Note the orientation of the substrate, and then remove it.
  • Move to the ProtoLaser, and continue with Step 2.

Step 2: Etching with the ProtoLaser

Step 3: Routing with the ProtoMat

Common Issues

  • Some issue
  • process_2s-noplate.1610413408.txt.gz
  • Last modified: 2021/01/11 20:03
  • by benh