This is an old revision of the document!
Double Sided, No Plating
Before starting, make sure:
Step 1: Process setup and first drilling on the ProtoMat
- After completion of Step 1, the ProtoMat will pause at a step called “Flip Material”.
- If it pauses at a step called “Dismount material” instead, DO NOT PANIC! You selected something during the Process Planning Wizard for through-hole plating equipment, when you should've left it blank. But no worries - simply leave the software and continue with these steps as though everything is hunky-dory.
- Once the software has paused, lift the ProtoMat's lid. Note the orientation of the substrate, and then remove it.
- Move to the ProtoLaser, and continue with Step 2.
Step 2: Etching with the ProtoLaser
Step 3: Routing with the ProtoMat