process_2s-noplate

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revisionPrevious revision
process_2s-noplate [2022/07/15 16:20] benhprocess_2s-noplate [2022/07/15 16:37] (current) benh
Line 29: Line 29:
  
   * **ProtoMat - The tool didn't drill out my holes!**   * **ProtoMat - The tool didn't drill out my holes!**
-You likely forgot to import the drill file. You'll have to restart the project over again. Sorry.+You likely forgot to import the drill file. If so, you'll have to restart the project over again. Sorry. Alternatively, the tool may have failed to pickup the bit correctly. In this case, come find a PI.
  
   * **ProtoMat - The tool exchange was botched!**   * **ProtoMat - The tool exchange was botched!**
-Stop the process as soon as possible, if it's still running. Go get a PI. If they don't know what to do, ask them to message our Slack channel. +Stop the process as soon as possible, if it's still running, even by lifting the lid. Go get a PI. If they don't know what to do, ask them to message our Slack channel. 
  
   * **ProtoMat - The drill hits are incorrect, or the routing path was wrong!**   * **ProtoMat - The drill hits are incorrect, or the routing path was wrong!**
Line 48: Line 48:
  
   * **ProtoLaser - The bottom/top didn’t etch completely.**   * **ProtoLaser - The bottom/top didn’t etch completely.**
-You can either restart the process entirely (hit the Play button, see figure 32) or right click on “Top Side” (or “Bottom side”) under “Processing” on the left, and click “Process from here” to restart the top (or bottom) side processing with top (or bottom) side alignment.+You can either restart the process entirely (hit the Play button, see figure 32) or right click on “Top Side” (or “Bottom side”) under “Processing” on the left, and click “Process from here” to restart the top (or bottom) side processing with top (or bottom) side alignment. Do first check to see if you can manually remove the strips, either with a scour pad or with a microscope and tweezers/a knife. It's usually faster, and less likely to ruin your board.
  
   * **ProtoLaser - The board is/is not flipped in the Processing tab.**   * **ProtoLaser - The board is/is not flipped in the Processing tab.**
  • process_2s-noplate.txt
  • Last modified: 2022/07/15 16:37
  • by benh