Differences
This shows you the differences between two versions of the page.
pcb-help_pm_0.15mm-drills [2022/07/13 19:19] – created benh | pcb-help_pm_0.15mm-drills [2022/07/13 21:04] (current) – benh | ||
---|---|---|---|
Line 1: | Line 1: | ||
+ | ===Making 0.15-mm Drill Hits=== | ||
+ | |||
You've reached the 0.15mm Drill Hits page! That probably means that you wants the down-low on drilling those super-duper tiny holes. | You've reached the 0.15mm Drill Hits page! That probably means that you wants the down-low on drilling those super-duper tiny holes. | ||
Line 6: | Line 8: | ||
- Setup your process, import your files, and add your fiducials, all as you would normally. | - Setup your process, import your files, and add your fiducials, all as you would normally. | ||
- | - Open the toolpath generation window (the fourth button, called " | + | - Open the toolpath generation window (the fourth button, called " |
+ | - In the bottom section (" | ||
+ | - For " | ||
+ | - For " | ||
+ | - Start the toolpath generation (click " | ||
+ | - Now go back into the Technology Dialog window. Change the " | ||
+ | - The results should now be adjusted correctly for the other drills, with the correct number of 0.15mm drill hits as well. {{ :: | ||
+ | |||
+ | When you save it after the correct toolpath generation, it will save with the 0.15mm drill hits. However, you'll have to do this every time you generate a toolpath with 0.15mm drill hits. | ||
+ | |||
+ | Good luck! |