pcb-help_pm

This is an old revision of the document!


Table of Contents

  1. Overview
  2. Q&A
  3. Common processing errors
    1. Software cannot/did not connect to the tool
    2. My gerber/drill file didn’t show up on the CAM view.
    3. The tool didn't drill out my holes!
    4. The tool exchange was botched!
    5. The drill hits are incorrect, or the routing path was wrong!

Overview


Q & A


Common processing errors

  • Software cannot/did not connect to the tool

First, make sure the ProtoMat hardware is on; if it's on already, there will be a red light under the toolhead (for the camera), and the status light on the toolhead should be at least blinking green. If it's not on, turn it on by toggling the green switch located underneath the cover, to the right of the working table, above the main power cable. Once you've confirmed the hardware is on, in the software, in the main toolbar (with the File menu), click “Machining” > “Connect”. Make sure that “S103” is selected in the dropdown menu and click “Connect”. Let the connection process happen, and then try the fabrication again.

  • My gerber/drill file didn’t show up on the CAM view.

You probably forgot to assign it a layer. If this happens, the software will put the gerbers onto their own layers that are named with the gerber's name. Try re-importing the files, and make sure you’ve assigned each file a Layer/Template (see figure 11). Also make sure to delete the incorrectly-generated layers (right-click and select “Delete”).

  • The tool didn't drill out my holes!

You likely forgot to import the drill file. You'll have to restart the project over again. Sorry.

  • The tool exchange was botched!

Stop the process as soon as possible, if it's still running. Go get a PI. If they don't know what to do, ask them to message our Slack channel.

  • The drill hits are incorrect, or the routing path was wrong!

There are a couple of possible reasons for this.

  1. You may not have imported the drill file or the board outline gerber correctly.
  2. The bits in the magazine may have been incorrect.
  3. The tool may have done something silly.

In any of these cases, there is no good solution other than to restart the project and double check all of these (if possible) before starting to re-process. Sorry.

  • pcb-help_pm.1610727281.txt.gz
  • Last modified: 2021/01/15 11:14
  • by benh