Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revisionLast revisionBoth sides next revision | ||
pcb-help_pm [2022/03/02 22:48] – benh | pcb-help_pm [2022/09/02 13:08] – benh | ||
---|---|---|---|
Line 4: | Line 4: | ||
- Overview | - Overview | ||
- Q&A | - Q&A | ||
+ | - How do I use the 0.15mm drill bit? | ||
+ | - Additional small bit information | ||
- Common processing errors | - Common processing errors | ||
- Software cannot/did not connect to the tool | - Software cannot/did not connect to the tool | ||
Line 40: | Line 42: | ||
---- | ---- | ||
=== Q & A === | === Q & A === | ||
+ | * How do I use the 0.15mm drill bit? | ||
+ | The LPKF sofware handles drill hits down to 0.2mm (7.5 mil) without any adjustments, | ||
+ | |||
+ | * Additional small bit information | ||
+ | The tool is most reliable with drill hits down to 0.4mm (15 mil), which is a pretty standard via size. For smaller bits, you're going to want to be very careful. The bits are quite fragile at this size and prone to breaking when either you or a PI or even the tool is handling them. "The tool?" you think. " | ||
---- | ---- |