Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revision | ||
pcb-fab [2022/06/22 12:48] – benh | pcb-fab [2022/09/07 17:55] (current) – benh | ||
---|---|---|---|
Line 18: | Line 18: | ||
=== Process Guides === | === Process Guides === | ||
- | - [[process_1S-noHoles|Single sided, no holes]] | + | - [[process_1S-noHoles|Single sided design, no holes]], regardless of plating. |
- | - [[process_1S-holes|Single sided, with holes]] | + | - [[process_1S-holes|Single sided design, with holes]], regardless of plating. |
- | - [[process_2S-noPlate|Double sided, no plating]] | + | - [[process_2S-noPlate|Double sided, no plating]], regardless of hole count. |
- | - [[process_2S-plate|Double sided, with plating]] | + | - [[process_2S-plate|Double sided, with plating]], regardless of hole count. |
- [[process_stencils|Solderpaste stencils]] | - [[process_stencils|Solderpaste stencils]] | ||
- [[process_reflowOven|Reflow oven]] | - [[process_reflowOven|Reflow oven]] | ||
Line 39: | Line 39: | ||
* //Copper thickness/ | * //Copper thickness/ | ||
* //Slot:// yes, but YMMV. See our [[pcb-tips|fabs tips]] page for details. | * //Slot:// yes, but YMMV. See our [[pcb-tips|fabs tips]] page for details. | ||
- | * // | + | * // |
* // | * // | ||
* // | * // | ||
Line 58: | Line 58: | ||
---- | ---- | ||
=== Process Specifications and Tolerances === | === Process Specifications and Tolerances === | ||
- | If you’re board passes OshPark’s specs ([[https:// | + | If you’re board passes OshPark’s specs ([[https:// |
- | ^ Specification ^ Minimum/Theoretical ^ Recommended ^ | + | ^ Specification ^ Theoretical |
- | | Trace width | + | | Trace width |
- | | Trace spacing (“pitch”) | 1 mils (0.025 mm) | 6 mils (0.15 mm) | | + | | Trace spacing (“pitch”) | 1 mils (0.025 mm) | 5 mils (0.15 mm) | |
- | | Polygon isolation | 10 mils (0.25 mm) | 30 mils (0.75 mm) | | + | | Polygon isolation | 10 mils (0.25 mm) | 24 mils (0.75 mm) | |
| Drill hit | 6 mil (0.15 mm) | 15 mil (0.4 mm) | | | Drill hit | 6 mil (0.15 mm) | 15 mil (0.4 mm) | | ||
| Drill X/Y resolution | +/- 0.01 mil (0.25 μm) || | | Drill X/Y resolution | +/- 0.01 mil (0.25 μm) || | ||
Line 70: | Line 70: | ||
| Drill hit | 0.05 mil (1.2 μm) || | | Drill hit | 0.05 mil (1.2 μm) || | ||
- | See our [[pcb-help|Knowledge Base]] and [[pcb-tips|Tips and Tricks]] pages for additional information. | + | **Note:** If you're considering a design at our theoretical minimum capabilities, |