Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revisionLast revisionBoth sides next revision | ||
pcb-fab [2022/07/15 16:42] – benh | pcb-fab [2022/09/02 12:51] – benh | ||
---|---|---|---|
Line 58: | Line 58: | ||
---- | ---- | ||
=== Process Specifications and Tolerances === | === Process Specifications and Tolerances === | ||
- | If you’re board passes OshPark’s specs ([[https:// | + | If you’re board passes OshPark’s specs ([[https:// |
- | ^ Specification ^ Theoretical Minimum ^ Recommended Minimum ^ | + | ^ Specification ^ Theoretical Minimum |
| Trace width | 1 mils (0.05 mm) | 5 mils (0.25 mm) | | | Trace width | 1 mils (0.05 mm) | 5 mils (0.25 mm) | | ||
| Trace spacing (“pitch”) | 1 mils (0.025 mm) | 5 mils (0.15 mm) | | | Trace spacing (“pitch”) | 1 mils (0.025 mm) | 5 mils (0.15 mm) | | ||
Line 70: | Line 70: | ||
| Drill hit | 0.05 mil (1.2 μm) || | | Drill hit | 0.05 mil (1.2 μm) || | ||
- | See our [[pcb-help|Knowledge Base]] and [[pcb-tips|Tips and Tricks]] pages for additional information. | + | **Note:** If you're considering a design at our theoretical minimum capabilities, |
- | + | ||
- | **Note:** If you're considering a design at our theoretical minimum capabilities, | + | |