Differences

This shows you the differences between two versions of the page.

--- pcb-basics [2020/05/31 17:11] – Clarified paragraph after PCB definition madeline
+++ pcb-basics [2021/01/13 14:18] – benh
@@ Line 31: / Line 31: @@
   - Design: Typically, one starts by developing a circuit, which may include simulations and/or prototyping on breadboard. The design of the board itself is then done on the computer using electronic computer-aided design (e-CAD) programs, such as KiCAD, EAGLE, or Altium, though there are many others.
-  - Fabrication: There are a number of different steps, depending on the complexity of your design, but a standard 2-layer board without vias begins by drilling any necessary holes, followed by etching/isolating the traces and components, and finally routing/cutting the board out. Soldermask and silkscreen can be applied after the board has been fabricated. See our "[[how-to-pcb|How to make a PCB at The Hive]]" page for details.
+  - Fabrication: There are a number of different steps, depending on the complexity of your design, but a standard 2-layer board without vias begins by drilling any necessary holes, followed by etching/isolating the traces and components, and finally routing/cutting the board out. Soldermask and silkscreen can be applied after the board has been fabricated. See "[[the-guide|The Official Fabrication Guide]]" page for step-by-step details.
   - Assembly: the process of actually adding the components to the fabricated PCB. At The Hive, we have soldering stations to facilitate this, as well as solder paste and a reflow oven if you'd prefer. We can also make solder paste stencils.