process_stencils

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revisionPrevious revision
Next revisionBoth sides next revision
process_stencils [2022/03/01 12:24] – benhprocess_stencils [2022/05/23 10:54] – benh
Line 23: Line 23:
 Before you start, you'll want to make sure that you have your solderpaste gerber files ready, along with your piece of polyimide. Note that we (typically) have either full 8x12 sheets, or a 24"-wide roll. If you need a full sheet, use one. Otherwise, use scissors to cut an appropriately-sized piece from the roll, making sure to leave enough room for a sizeable (~1 inch) frame/boarder around the design. Before you start, you'll want to make sure that you have your solderpaste gerber files ready, along with your piece of polyimide. Note that we (typically) have either full 8x12 sheets, or a 24"-wide roll. If you need a full sheet, use one. Otherwise, use scissors to cut an appropriately-sized piece from the roll, making sure to leave enough room for a sizeable (~1 inch) frame/boarder around the design.
  
-  - Log into the ProtoLaser. Turn on the tool and/or start the software if they are not already on and running.+  - Log into the ProtoLaser. Turn on the tool and/or start the software if they are not already on and running. Brush off the processing surface; it needs to be clear of debris so that the polyimide can sit flat.
   - Start a new project ("File" > "New").    - Start a new project ("File" > "New"). 
   - Select the "Stencil" template. (Note: I'm not sure what the "short" version is, so just use the regular one.)   - Select the "Stencil" template. (Note: I'm not sure what the "short" version is, so just use the regular one.)
  • process_stencils.txt
  • Last modified: 2024/03/03 12:48
  • by benh