Differences
This shows you the differences between two versions of the page.
| Next revision | Previous revisionNext revisionBoth sides next revision | ||
| pcb-help_fab [2021/01/13 22:16] – created benh | pcb-help_fab [2021/01/13 22:47] – benh | ||
|---|---|---|---|
| Line 1: | Line 1: | ||
| + | Book of Kane (Northforge Fabrication' | ||
| + | |||
| I’m ready to have my board professional fabricated. Do you have any recommendations? | I’m ready to have my board professional fabricated. Do you have any recommendations? | ||
| We don’t officially recommend any of the following fabrication houses. All of them have positives and negatives. | We don’t officially recommend any of the following fabrication houses. All of them have positives and negatives. | ||
| - | |||
| - | |||
| - | Some additional notes on board design and fabrication: | ||
| - | * Slots are hard in this process. Please consider using a single drill hit that’s wide enough if possible. If it’s unavoidable, | ||
| - | * Plating is typically avoidable by making vias with a diameter of 40 mil (1 mm). A standard 0.1” header pin can then be pushed through and soldered on both the top and bottom. | ||
| - | * Higher polygon isolation will reduce the chance of bridging to a plane during assembly (since we don’t really offer soldermask). However, it will also increase etch time. | ||
| - | |||
| - | Slots\\ | ||
| - | Substrate thickness | ||
| ===Fabrication=== | ===Fabrication=== | ||