Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revision | Next revisionBoth sides next revision | ||
pcb-training [2021/01/19 12:51] – benh | pcb-training [2021/01/19 12:56] – benh | ||
---|---|---|---|
Line 1: | Line 1: | ||
==== How to get PCB trained ==== | ==== How to get PCB trained ==== | ||
- | {{ : | + | |
=== Table of Contents === | === Table of Contents === | ||
- Basics | - Basics | ||
Line 37: | Line 37: | ||
** What is SUMS? **\\ | ** What is SUMS? **\\ | ||
- | If " | + | If " |
Line 61: | Line 61: | ||
**Where can I find the videos?**\\ | **Where can I find the videos?**\\ | ||
- | All PCB training and scheduling is all handled on SUMS. If you want to know more about SUMS, you can find in-depth information and a lot more FAQs in our [[https://drive.google.com/open?id=1XLLOS43sQd6rzWll8cAxkvRiArmIGGvpcC-y9uXCOek|SUMS Guide]]. \\ | + | All PCB training and scheduling is all handled on SUMS. If you want to know more about SUMS, you can find in-depth information and a lot more FAQs in our [[https://gtvault.sharepoint.com/: |
\\ | \\ | ||
If you have never been to The Hive before, you’ll need to join our " | If you have never been to The Hive before, you’ll need to join our " | ||
Line 110: | Line 110: | ||
**What if I don’t successfully complete the checkoff? | **What if I don’t successfully complete the checkoff? | ||
- | Schedule another checkoff following the same procedure. It is strongly recommended that you rewatch the training videos or read up on the fabrication process | + | Schedule another checkoff following the same procedure. It is strongly recommended that you rewatch the training videos or read up on the fabrication process |
**Can I bring my own design to fabricate instead of the training board for my checkoff? | **Can I bring my own design to fabricate instead of the training board for my checkoff? | ||
Probably not. It is, however, at the discretion of your trainer. If the board is small, simple, and on FR4/FR5, (i.e. very similar to the training board), then it might be fine. However, large boards can take an hour or more to etch just one side. Since most boards are larger than the training one, you will likely have to stick with the training board. It will be easier for everyone (especially if it fails), and afterwards you can simply schedule time on the tools to fabricate whatever you’d like. | Probably not. It is, however, at the discretion of your trainer. If the board is small, simple, and on FR4/FR5, (i.e. very similar to the training board), then it might be fine. However, large boards can take an hour or more to etch just one side. Since most boards are larger than the training one, you will likely have to stick with the training board. It will be easier for everyone (especially if it fails), and afterwards you can simply schedule time on the tools to fabricate whatever you’d like. |