pcb-training

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
pcb-training [2021/01/19 12:56]
benh
pcb-training [2021/06/03 21:26] (current)
benh
Line 2: Line 2:
  
 === Table of Contents === === Table of Contents ===
 +  - TL;DR
   - Basics   - Basics
     * Will the PIs at the Hive make a board for me?     * Will the PIs at the Hive make a board for me?
Line 22: Line 23:
     * Can I bring my own design to fabricate instead of the training board for my checkoff?     * Can I bring my own design to fabricate instead of the training board for my checkoff?
 ----- -----
 +=== TL;DR ===
 +The Hive is home to a suite of equipment that enable our users to fabricated PCBs without much manual work. Once trained, users have access to these tools and all the materials we have as long as the space is available. Training is handled through SUMS, and is done in three steps:
  
-=== Introduction ​=== +  - Training videos - watch them all on your own time and at your own pace. 
 +  - Quiz - ten questions, get nine to proceed. 
 +  - Checkoff - show off what you've learned by fabricating the board from the training videos in a one-on-one session with a trainer. Complete it in two hours, and the tools are your for the using. 
 + 
 +Read on for more details about this process, or [[https://​www.sums.gatech.edu/​SUMS_React/​View_Equipment_React?​DepartmentId=87&​ToolId=1998|head directly to SUMS]] to get started. 
 + 
 +----- 
 +=== Basics ​=== 
  
 **Will the PIs at the Hive make a board for me?**\\ **Will the PIs at the Hive make a board for me?**\\
  • pcb-training.txt
  • Last modified: 2021/06/03 21:26
  • by benh