pcb-help_pl

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revisionPrevious revision
Next revisionBoth sides next revision
pcb-help_pl [2021/10/07 14:13] – Added solution to pressure error. madelinepcb-help_pl [2021/10/08 12:43] – Added solution for cutting/drilling toolpaths madeline
Line 63: Line 63:
  
   * **The bottom/top didn’t etch completely.**   * **The bottom/top didn’t etch completely.**
-You can either restart the process entirely (hit the Play button, see figure 32) or right click on “Top Side” (or “Bottom side”) under “Processing” on the left, and click “Process from here” to restart the top (or bottom) side processing with top (or bottom) side alignment.+You can either restart the process entirely (hit the Play button, see figure 32) or right click on “Top Side” (or “Bottom side”) under “Processing” on the left, and click “Process from here” to restart the top (or bottom) side processing with top (or bottom) side alignment. You can also do this for an individual tool or an individual tool for a single scan field.
  
   * **The board is/is not flipped in the Processing tab.**   * **The board is/is not flipped in the Processing tab.**
 On the left of the screen, make sure nothing is selected under “Processing”. If there is, hold down either CTRL (on Windows) or the command key (on Mac) and then left click to de-select it. If that doesn’t fix it, you can select either “Bottom Side” or “Top Side” (again, on the left) to force the correct orientation. You can try starting the project over again if this doesn’t solve it as well. Sometimes, the software has bugs. On the left of the screen, make sure nothing is selected under “Processing”. If there is, hold down either CTRL (on Windows) or the command key (on Mac) and then left click to de-select it. If that doesn’t fix it, you can select either “Bottom Side” or “Top Side” (again, on the left) to force the correct orientation. You can try starting the project over again if this doesn’t solve it as well. Sometimes, the software has bugs.
 +
 +  * **The toolpath generates drilling or cutting operations.**
 +Usually, this happens because the "supported by ProtoMat" box was not checked when you selected the template. Because the ProtoLaser does not know that you are using the ProtoMat for drilling and contour routing, it will try to do it itself. Reselect the template, making sure this box is checked.
  
   * **The software throws and "Insufficient pressure" error.**   * **The software throws and "Insufficient pressure" error.**
  • pcb-help_pl.txt
  • Last modified: 2022/07/18 18:06
  • by benh